Thingiverse
Shaving Station
178
Downloads
172
Likes
2
Makes
Just a simple shaving station to hold a razor, two bottles/tubes, and a cartridge of blades.
If you don't use DSC then I have some dimensions for the holders.
Razor cartridge - 92 mm x 50 mm x 15 mm (3 5/8 in x 2 in x 5/8 in)
Bottles/Tubes - anything under 50 mm (2 in) Diameter will fit
If your printer is good at bridging then you can skip the support material since it is only there to support the top of the drawer slot, it can get hard to remove, but just keep trying and you'll get it.
If you don't use DSC then I have some dimensions for the holders.
Razor cartridge - 92 mm x 50 mm x 15 mm (3 5/8 in x 2 in x 5/8 in)
Bottles/Tubes - anything under 50 mm (2 in) Diameter will fit
If your printer is good at bridging then you can skip the support material since it is only there to support the top of the drawer slot, it can get hard to remove, but just keep trying and you'll get it.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in