Thingiverse
Frontierfila 1KG Spoolholder
by zipni
3
Downloads
3
Likes
0
Makes
Simple little holder i made for Frontierfila 1KG spools. made with Fusion360.
requires 22x8x7 bearings, wich will fit neatly with little tap of hammer. Holder also "clicks" on spool it is just the right size for it, 58mm diameter to be exact. Will allow spools to hang on 8mm rod very close to each other and rolls super smooth!
Printed with 2 top&bottom layers, 2 walls and about 40% Grid infill.
Printed "bottom" down, model requires rotating 90 degrees. Had suppports for smaller hole (se
requires 22x8x7 bearings, wich will fit neatly with little tap of hammer. Holder also "clicks" on spool it is just the right size for it, 58mm diameter to be exact. Will allow spools to hang on 8mm rod very close to each other and rolls super smooth!
Printed with 2 top&bottom layers, 2 walls and about 40% Grid infill.
Printed "bottom" down, model requires rotating 90 degrees. Had suppports for smaller hole (se
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in