Thingiverse
JG Aurora A5 Levelling Knob
by indyToronto
149
Downloads
121
Likes
2
Makes
2018.02.06 (edit)
A few people seems to indicate that the fitting is too tight. Print one first at +5% if you want a loose fit and can use superglue. The stock nut should extend past the top to make it turn smoother.
---------------
The original levelling knobs on the JGAURORA A5 are too small and too difficult to turn, but there's not a lot of space to grow the knob. I decided to design one to make it a little easier to level.
However it is still very small as the space is to
A few people seems to indicate that the fitting is too tight. Print one first at +5% if you want a loose fit and can use superglue. The stock nut should extend past the top to make it turn smoother.
---------------
The original levelling knobs on the JGAURORA A5 are too small and too difficult to turn, but there's not a lot of space to grow the knob. I decided to design one to make it a little easier to level.
However it is still very small as the space is to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in