Thingiverse
Radiator bleed key
by BugHunt
10
Downloads
8
Likes
0
Makes
Radiator bleed key, designed with a hole of 5mm + 0.1mm or 0.2mm margins. The outer diameter is 9.5mm.
I needed a sturdy bleeding key which I could use multiple times and had a cord hole on top.
Since I could not find it on Thingiverse at the time, I designed it myself from scratch using Fusion 360.
It is quite a tight fit, so be a bit careful when inserting it to the radiator pin.
The keys in the photo are the 0.1mm margin version.
The key has been tested at home, enjoy the print :-)
I needed a sturdy bleeding key which I could use multiple times and had a cord hole on top.
Since I could not find it on Thingiverse at the time, I designed it myself from scratch using Fusion 360.
It is quite a tight fit, so be a bit careful when inserting it to the radiator pin.
The keys in the photo are the 0.1mm margin version.
The key has been tested at home, enjoy the print :-)
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in