Thingiverse
Wallmounted Spolholder
by dbauer
1
Downloads
2
Likes
0
Makes
This is my wall mounted Spool holder.
It fits 1 used and 6 inactive spools of filament through the help of a 15cm long 8mm thick threaded rod.
The are mounted the following: nut, washer, wood, washer, nut.
To hold the used spool i use two ordinary wooden corners, which are simlpy screwed onto the board. The board dimensions are 40cm x 100cm. On top of the i glued the two rodmounts. The spool hangs on a 7mm Ø alubrass rod, The rod is glued into to grip with two component epoxy glue.
The exact
It fits 1 used and 6 inactive spools of filament through the help of a 15cm long 8mm thick threaded rod.
The are mounted the following: nut, washer, wood, washer, nut.
To hold the used spool i use two ordinary wooden corners, which are simlpy screwed onto the board. The board dimensions are 40cm x 100cm. On top of the i glued the two rodmounts. The spool hangs on a 7mm Ø alubrass rod, The rod is glued into to grip with two component epoxy glue.
The exact
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in