Thingiverse
15mm SciFi Barricade Scenery
by Category
198
Downloads
103
Likes
1
Makes
A simple science-fiction barricade, designed for 15mm miniature gaming. This was made to add some partial cover to my gaming table, and it's been pretty successful!
The picture above shows this printed at 100% - which may seem a little low, depending on which figure range you are using. Anywhere between 100%-125% seems to work with my figures, but anything above 125% it seems too tall to count as partial cover, and starts seeming out-of-place as a barricade.
Made using FreeCAD
[As poste
The picture above shows this printed at 100% - which may seem a little low, depending on which figure range you are using. Anywhere between 100%-125% seems to work with my figures, but anything above 125% it seems too tall to count as partial cover, and starts seeming out-of-place as a barricade.
Made using FreeCAD
[As poste
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in