Thingiverse
CR-10 PSU Bracket for Ikea Lack Table
by goldfly
37
Downloads
17
Likes
0
Makes
Simply remove the rubber feet on the CR-10 PSU using the supplied allen wrench and attach this bracket with the same screws you just took off.
- Added slots to account for printer calibration differences.
- I printed at 30-35% infill, both were fine.
- I used supports in the middle of the slots, but you may not need them.
If you make one be sure to post it! Always fun to see what others have done.
- Added slots to account for printer calibration differences.
- I printed at 30-35% infill, both were fine.
- I used supports in the middle of the slots, but you may not need them.
If you make one be sure to post it! Always fun to see what others have done.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in