Thingiverse
Anet A8 spool holder HOLDERS (not another...) - bor3d.it
by bor3d
34
Downloads
27
Likes
0
Makes
1) My base philosophy is to re-use the things, save money and time, not to waste precious filament.
2) If you are a lucky owner of a Anet A8, you already have the basic black spool holder (two "A" pieces with a short threaded bar). It works but is really bulky and comfortless.
On the basis of the previous two points I decided to concretize two small support (very cheap compared to other holders e.g.thing:1505075: 0.5USD vs 1.8USD) and place the original Anet holder on the top of the printe
2) If you are a lucky owner of a Anet A8, you already have the basic black spool holder (two "A" pieces with a short threaded bar). It works but is really bulky and comfortless.
On the basis of the previous two points I decided to concretize two small support (very cheap compared to other holders e.g.thing:1505075: 0.5USD vs 1.8USD) and place the original Anet holder on the top of the printe
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in