Thingiverse
Robo 3D R1+Plus 60mm Hobbed Bolt Fitting with Wiring Arm
by crorsina
8
Downloads
3
Likes
0
Makes
I needed to replace my extruder's stock M8x50mm hobbed bolt. That size does not seem to be widely available, but I found a few 60mm ones. I also recently had to remove the zip ties from the extruder's wiring, so I wanted a way to better secure all that. The combination of those issues resulted in this design.
The bearing and washer are taken from the gear side of the existing hobbed bolt and reused. With the wiring zip tie removed, I can't see any purpose in continuing to use a bearing as
The bearing and washer are taken from the gear side of the existing hobbed bolt and reused. With the wiring zip tie removed, I can't see any purpose in continuing to use a bearing as
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in