Thingiverse
ER20 Collet
26
Downloads
33
Likes
0
Makes
I wanted to make a collet tray for my ER20 collets, so I drew these collet models to help me do it. I found that the measurements and standards vary a bit, so I actually came up with 3 different models. The inch model is based on the drawing I found on the MariTool website, the metric model is based on the drawing I found on AliExpress, and the measured model is based on my own caliper work with the set of DrillPro collets that I ordered from BangGood. All 3 models are based on the same 30deg no
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in