Thingiverse
USB power distributor
by andreiavram
14
Downloads
12
Likes
0
Makes
Realizing that 3 or 4 of my 5 power sockets on my desk were used by 5V USB adapters, I decided to replace them all with a USB power distributor. The part is designed to fit 5 of these: https://www.tme.eu/gb/details/mx-48408-0003/usb-ieee1394-connectors/molex/48408-0003/ with a little bit of wiggle room to spare.
The part is designed in FreeCad (0.17), source file available.
The rim is designed to allow top placement (with adhesive tape or similar) in any place you can cut out a bottom / po
The part is designed in FreeCad (0.17), source file available.
The rim is designed to allow top placement (with adhesive tape or similar) in any place you can cut out a bottom / po
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in