Thingiverse
MKS SBase v1.3 Mount for Wanhao i3 / Maker Select v2
by Michaelwu21
18
Downloads
7
Likes
0
Makes
A mount that screws on the melzi board holes and has room for a large MKS/Trigorilla Mosfet.
It's split into 2 parts to be printable, any thermoplastic will work. I personally did not glue the two pieces together as I found that screwing the board in kept them aligned.
No extra screws are needed, all screws are reused except for the Mosfet. I just used some screws I had lying around with a spacer(m4 nut) between the mosfet and mount.
To set up the board, I found these tutorials to be
It's split into 2 parts to be printable, any thermoplastic will work. I personally did not glue the two pieces together as I found that screwing the board in kept them aligned.
No extra screws are needed, all screws are reused except for the Mosfet. I just used some screws I had lying around with a spacer(m4 nut) between the mosfet and mount.
To set up the board, I found these tutorials to be
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in