Thingiverse
50mm LED Strip Rail for 2020 Extrusion
by Mike_381
29
Downloads
9
Likes
0
Makes
No supports needed if printed in the vertical position.
With good first layer adhesion I have printed 100mm length in the vertical position (no raft)
Highest I have printed in vertical position with 8mm raft is 133mm length
You could probably get away with a 150mm length with raft in this position, but anything longer, I would recommend printing in the horizontal position.
This is a remix of the original by J-Max
Reason for redesign, my LED strip was 2mm wider than what would fit into the L
With good first layer adhesion I have printed 100mm length in the vertical position (no raft)
Highest I have printed in vertical position with 8mm raft is 133mm length
You could probably get away with a 150mm length with raft in this position, but anything longer, I would recommend printing in the horizontal position.
This is a remix of the original by J-Max
Reason for redesign, my LED strip was 2mm wider than what would fit into the L
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in