Thingiverse
Raspberry Pi Zero W USB Dongle Case, Modded Header/USB-Pos/Heat-Sink
by esra
36
Downloads
26
Likes
0
Makes
Instead of gluing my USB-Connector or buying a interface pcb, I just reused an USB-Connector from a old DVB-T-Stick and soldered it right to the ground pads of the unmounted connector. (Quick&Dirty)
Because the pads for that unmounted connector are not right in the middle, I had to move the breakthrough for the USB a bit.
I liked to have access to I2C, but not to all header-pins and I wanted the possibility to use a heat sink.
To do all this I added some parameters and lines to the scad-f
Because the pads for that unmounted connector are not right in the middle, I had to move the breakthrough for the USB a bit.
I liked to have access to I2C, but not to all header-pins and I wanted the possibility to use a heat sink.
To do all this I added some parameters and lines to the scad-f
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in