Thingiverse
Li-Ion 18650 5x1 Battery Pack for My 3D Printer's Backup Power
by moze13
47
Downloads
41
Likes
0
Makes
I design it to make 3s5p battery pack from scratch for my 3d printer backup power.
I use 3s 25A li-ion bms board to protect the battery pack and connect its terminal directly to 3d printer's 12V power supply (after adjusting the voltage to 12.6V, as fully charged single li-ion would reach 4.2V, so 4.2*3=12.6).
The batteries itself was cheap used 18650 battery with 5A rating each.
It did save me a lot as I'm currently live in house with small rated circuit breaker which frequently cut off.
I use 3s 25A li-ion bms board to protect the battery pack and connect its terminal directly to 3d printer's 12V power supply (after adjusting the voltage to 12.6V, as fully charged single li-ion would reach 4.2V, so 4.2*3=12.6).
The batteries itself was cheap used 18650 battery with 5A rating each.
It did save me a lot as I'm currently live in house with small rated circuit breaker which frequently cut off.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in