Conterpart for the Avid Artisan Deadalus (right height)

I remixed the original to fit for the deadalus coil maker.
The center of the bearing lines up with the center of the drill from deadalus now.

Additional parts you will need:
1 bearings: http://amzn.to/2ofEido

Print settings

Infill: 100%
Layer: 0,2mm
Nozzle: 230 - 245°C
Bed: 70-75°C
Support: no
Raft: no

Used filament:
Yellow: http://amzn.to/2GrlK1n


I used the following tape on my CR-10:
http://amzn.to/2zXjJGu
This stuff is really great, no extra glue needed, 100% stick