ANET_A6_1KG+ HEAVY_SPOOL_HOLDER_FILAMENT_GUIDE / LIGHT

The Spool Daddy
[Slightly Better than the print pictured. (Shortened, CREE light and wire loom loc add.)]
Print parts as set on pallet.
No Supports Required except for the filament guide from the build plate.

Tolerances Met, Test Prints Fit beauty.
2 to 4mm wall 70 to 100 percent fill on everything except the holder part @ 50-70 % fill
.3mm layer height works fine.
-Should lend itself to print with volcano and 1mm nozzle-

Supplies
12 Volt Cree Button LED light x 2
https://www.ba