28 weeks later - hueforge

Hueforge of 28 weeks laterThe photos shows the result in 200*150mm and a nozzle of 0.4Boost MeThanks for your boost!You can change the X and Y dimensions but do not change the Z dimensions You must define the printing parameters indicated in the description below and change the filament on the indicated layers. You can use filaments other than those indicated, but the result will differ. You can use any black PLA Hueforge descriptionPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 134.84x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 1.8mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 3 unique filaments Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Red At layer #12 (1.04mm) swap to Jade White for the rest.