Thingiverse
CNC Drag Knife (Prototyp 5)
by erdinand3000
6
Downloads
8
Likes
0
Makes
I tested it today but doesnt work.
The weight below the bearings is too high and the idea of a pla slide axis is just not smooth enough to let it spin.
PROTO6 will deal with this problem and with the length from cut point to bearing (Scalpel blade =4cm) so the blade should fit into a bearing
18.02.
PROTO3 is enable to cut but it doesnt get the Corners right. PROTO4 will need to get a good offset setting AND blade height setting.
It uses some springs which fit between the inner and out
The weight below the bearings is too high and the idea of a pla slide axis is just not smooth enough to let it spin.
PROTO6 will deal with this problem and with the length from cut point to bearing (Scalpel blade =4cm) so the blade should fit into a bearing
18.02.
PROTO3 is enable to cut but it doesnt get the Corners right. PROTO4 will need to get a good offset setting AND blade height setting.
It uses some springs which fit between the inner and out
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in