Thingiverse
Anet A8 and others Lightweight x Carriage with bltouch mount
by bexwhitt
6
Downloads
2
Likes
0
Makes
The X Carriage was remixed with ziptip anchors.
Included is the fusion 360 file so you can take off the Bltouch mount or replace it with another probe.
The square mount to the carriage has m3 nut traps in it but you will need exactly the correct length of bolt, the holes are small enough though to use without nuts as I do.
On my Bltouch a m3 nut above it below the mount makes it the correct height.
As the belt is held at the top not the bottom it makes the x go the wrong way change t
Included is the fusion 360 file so you can take off the Bltouch mount or replace it with another probe.
The square mount to the carriage has m3 nut traps in it but you will need exactly the correct length of bolt, the holes are small enough though to use without nuts as I do.
On my Bltouch a m3 nut above it below the mount makes it the correct height.
As the belt is held at the top not the bottom it makes the x go the wrong way change t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in