Thingiverse
Reinforced cooling fan duct for ender 2
by Nick_Groot
62
Downloads
47
Likes
0
Makes
This is a remix of Timah81s "Cr10 40mm cooling duct with beefed up mount".
https://www.thingiverse.com/thing:2350437
Because i also installed the "Radial Fan Fang for Creality CR-10
by jneilliii" https://www.thingiverse.com/thing:2237084 on my Ender 2, i found that mounting all that gear to the x-carriage only with the two M3 screws the hotend is held by a bit flimsy/wiggly.
So i added an ear with two holes, now the whole assembly can be fixed also on the left side with the stock extrude
https://www.thingiverse.com/thing:2350437
Because i also installed the "Radial Fan Fang for Creality CR-10
by jneilliii" https://www.thingiverse.com/thing:2237084 on my Ender 2, i found that mounting all that gear to the x-carriage only with the two M3 screws the hotend is held by a bit flimsy/wiggly.
So i added an ear with two holes, now the whole assembly can be fixed also on the left side with the stock extrude
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in