Thingiverse
SCX200 - Fenix R1 Pod
by FENIX_
4
Downloads
2
Likes
0
Makes
Update - R1.2 (ignore the numbering on the print as I didnt update it)
Two minor mods;
1. When using a 2.1mm lens (my go to) the corners of the image were obscured by the pod. Diagonals of the cam protection have been removed and now only the tiniest amount of the pod can be seen in the corners. You really have to look to see it its that small.
2. The fin broke after a couple of gates so it has been made thicker. I guess it was doing its job of protecting the antenna... and it worked
Two minor mods;
1. When using a 2.1mm lens (my go to) the corners of the image were obscured by the pod. Diagonals of the cam protection have been removed and now only the tiniest amount of the pod can be seen in the corners. You really have to look to see it its that small.
2. The fin broke after a couple of gates so it has been made thicker. I guess it was doing its job of protecting the antenna... and it worked
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in