Thors Hammer

---- Thors Hammer ----

I tried to make a "Thors Hammer" for my kid, I think it came out well enough to share.

I sliced it with Simplify3D
The Endcap I printed in 0.20 (infill 100% and Support)
The Shaft in 0.24 (infill 40%)
The Head in 0.24 (infill 50% in bottom where the threads are, 10% in the middle, and 40% from a few layers before the top layers start)

This is just how I printed mine, just make sure to have enough infill around the threads and in the top.

NB. If you are unabl