Thingiverse
Airsoft Vortex Block for 1-1/4 in SCH 40 pipe
by Bushwookie
15
Downloads
9
Likes
0
Makes
This is designed to be a one-piece vortex block for airsoft use. This is the kind used for the EE-05 "Montag" Flamethrower as seen on our airsoft teams facebook page. https://www.facebook.com/pg/EEskunkworks/photos/?tab=album&album_id=2048200882058318
the air inlet hole is 0.32 inches in diameter (to be able to be tapped - just be sure to use enough perimeters), and the outlet hole is designed to be a loose fit for standard AEG barrels, suggested to use Epoxy to make the barrel stay in
the air inlet hole is 0.32 inches in diameter (to be able to be tapped - just be sure to use enough perimeters), and the outlet hole is designed to be a loose fit for standard AEG barrels, suggested to use Epoxy to make the barrel stay in
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in