Thingiverse
CR10S-Fan-Shroud
by ESEAone
174
Downloads
90
Likes
1
Makes
This is an adaptation to "Hanphry's" "CR-10_Fan_Mod_-_easy_to_install" fan duct mod.
I have put the exit of the duct centered on the print nozzle.
Have added extra support to the screw tabs, this makes the unit a little wider than the fan but not as wide as the print head cover. I have also added a 1° angle to the mounting surface in way of the screws, this will help the duct nozzle side from hanging low and hitting the print.
Modified the vertical duct wall's to aid airflow and removed the
I have put the exit of the duct centered on the print nozzle.
Have added extra support to the screw tabs, this makes the unit a little wider than the fan but not as wide as the print head cover. I have also added a 1° angle to the mounting surface in way of the screws, this will help the duct nozzle side from hanging low and hitting the print.
Modified the vertical duct wall's to aid airflow and removed the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in