Thingiverse
Raspberry Pi Zero enclosure
by Raylux
15
Downloads
3
Likes
0
Makes
I edited the raspberry pi zero enclosure made by Melfafa58.
This one is slightly thinner to better hold the edge of the board, with a small extension on the inside to let the lid catch on the one side. I also removed the lid catch on the other side and made it flush to sit better in the existing groove. I extended the gap at the bottom to make space for the camera connector so that the ports would better line up with the holes for them.
This one is slightly thinner to better hold the edge of the board, with a small extension on the inside to let the lid catch on the one side. I also removed the lid catch on the other side and made it flush to sit better in the existing groove. I extended the gap at the bottom to make space for the camera connector so that the ports would better line up with the holes for them.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in