Thingiverse

Rotating Prusa Death Star Topper

by Ryan1705

143 Downloads

129 Likes

0 Makes

Download Model

awesome cool death star gadget gears moving prusa i3 prusa i3 mk2 star wars awesome cool death star gadget gears moving prusa i3 prusa i3 mk2 star wars

After much testing, it is complete. I present the Rotating Death star. you will need to print the Hex base, Z-gear and the Death Star Gear. The blank one if for remixes (detail below). I have been warned that this may cause layershifts on your prints. I have tested this for over 30 hours of prints, nothing bad has yet happened, it may even have fixed my Z-wobble alittle. There is good clearance between the Z-gear and the sides of the hole it is in, and the whole setup does not load your stepper

Source

Thingiverse

Comments

Makes