Thingiverse
CR-10 Filament sensor 2020 mount
by stmorgan
38
Downloads
10
Likes
1
Makes
A mount for the CR-10S filament sensor intended to be used with QuadBert's 2020 rollers.
https://www.thingiverse.com/thing:1409186
The sensor box is the same one I've printed and successfully used on one of my integrated relocation mounts, the 2020 mount is untested, but intended to be used with the same blocks from the above mentioned roller so that it's free sliding, or Tnuts could be used for a fixed mount. Print one mount, one lid, heat set two 3mm nuts into the recesses with a solderin
https://www.thingiverse.com/thing:1409186
The sensor box is the same one I've printed and successfully used on one of my integrated relocation mounts, the 2020 mount is untested, but intended to be used with the same blocks from the above mentioned roller so that it's free sliding, or Tnuts could be used for a fixed mount. Print one mount, one lid, heat set two 3mm nuts into the recesses with a solderin
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in