Thingiverse
Filament Enclosure Tap Cap Leash
by nameek
164
Downloads
101
Likes
0
Makes
This is an adaptation of dottom22's "Filament Enclosure Tap (1.75mm)
https://www.thingiverse.com/thing:2139021
I designed this strap to restrain the caps I had already printed, so I drilled a hole in the center of the cap and used a drop of CA to lock in the "button" . I also included a version of the cap with a hole already in it for those who would prefer to avoid drilling.The slot at the small hole makes it possible to remove/replace the leash later. (or install the leash AFTER gluing t
https://www.thingiverse.com/thing:2139021
I designed this strap to restrain the caps I had already printed, so I drilled a hole in the center of the cap and used a drop of CA to lock in the "button" . I also included a version of the cap with a hole already in it for those who would prefer to avoid drilling.The slot at the small hole makes it possible to remove/replace the leash later. (or install the leash AFTER gluing t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in