Thingiverse
DreamPi - Raspberry Pi B+ / 2 / 3 Case With Cooling Fan
by FoxTail
134
Downloads
104
Likes
2
Makes
Iconic Sega Dreamcast Case for Raspberry Pi B+ / 2 / 3
Fits with a 30mm x 30mm x 10mm Cooling Fan (Refer to GPIO Pins for Power Source)
Requirements :
Cooling Fan : 4 Screws + 4 Nuts
Raspberry Pi : 4 Screws
Case : 2 Screws
You must use a Raft + Supports to print the Top part (cannot be printed without supports) / You must use a Raft to print the Bottom Part. If you don't use rafts (or a heatbed), the deformations (warping) will be visible when you assemble the case.
All the little par
Fits with a 30mm x 30mm x 10mm Cooling Fan (Refer to GPIO Pins for Power Source)
Requirements :
Cooling Fan : 4 Screws + 4 Nuts
Raspberry Pi : 4 Screws
Case : 2 Screws
You must use a Raft + Supports to print the Top part (cannot be printed without supports) / You must use a Raft to print the Bottom Part. If you don't use rafts (or a heatbed), the deformations (warping) will be visible when you assemble the case.
All the little par
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in