Thingiverse
Centrifugal fan for 5V DC motor.
by gimle
49
Downloads
57
Likes
0
Makes
Centrifugal fan for 24.5x18.5mm (plane measurements) 5V DC motor.
Assembly tips:
- Fan center hole is a bit smaller than the motor shaft, either adjust with a small drill or heat fit if using PLA.
- The fan seems to self align a bit with high RPM, so some wobble/scratching when moving manually might not be a problem.
- Add insert while running to just before it starts scratching for a tight fit and add glue to the seam.
Remix of Warren_3Deee Squirrel-cage fan, changes are: ,
- enlarg
Assembly tips:
- Fan center hole is a bit smaller than the motor shaft, either adjust with a small drill or heat fit if using PLA.
- The fan seems to self align a bit with high RPM, so some wobble/scratching when moving manually might not be a problem.
- Add insert while running to just before it starts scratching for a tight fit and add glue to the seam.
Remix of Warren_3Deee Squirrel-cage fan, changes are: ,
- enlarg
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in