Tronxy P802M Vertical X-Brace

Although the bracing on the Tronxy P802M is quite good, this makes it even better.

Simple but effective design using 4 M3 10mm screws and 8mm screw rod. Go to your local hardware store and buy some 8mm rod (cost me $2.50 for a 60cm rod).

Cut each rod to 26.5cm and screw all the way into the bottom section (best to do this when plastic is still warm). Hold bottom rod in place with M3 screw. Screw in top section but not all the way. Mount bottom section using one of the already used M3 20mm