Thingiverse
Duet Wifi Case
by YogiG
311
Downloads
154
Likes
3
Makes
A case designed around the Duet Wifi, design choices were to focus on airflow while remaining svelte.
- Two 50mmx10 fans directing air over and above board. Channels to direct air under stepper drivers.
- Built in zip tie points along wall for cable management and two more in front to secure power and bed wires.
- Full rear panel access without having to remove anything.
- Reference notes recessed on inside wall for wire layout.
- Screws are threaded for M4-7 (10mm long is what I'm usin
- Two 50mmx10 fans directing air over and above board. Channels to direct air under stepper drivers.
- Built in zip tie points along wall for cable management and two more in front to secure power and bed wires.
- Full rear panel access without having to remove anything.
- Reference notes recessed on inside wall for wire layout.
- Screws are threaded for M4-7 (10mm long is what I'm usin
Makes
Did you print this model? Sign in and share your make!
![Reflow Hot Plate - Controller Board [CASE]](https://wsrv.nl/?url=https%3A%2F%2Fmedia.printables.com%2Fmedia%2Fprints%2F1217156%2Fimages%2F9198613_d28073bc-9a9c-49b4-a0b4-4c14a3f38734_dd7287a6-40b7-427b-afe8-b0a1bc6240b2%2Fimg-20250305-wa0047e.jpg&w=400&h=300&fit=cover&output=webp&q=80)
Sign in to leave a comment
Sign in