Thingiverse
E3D V6, 40mm Fan, Double Fan Duct
by Legriano
32
Downloads
20
Likes
1
Makes
This is a 5015 Fanduct + 40mm Hot End Cooling Fan combo for the E3D V6 Hotend.
It fits the stock X-axis from the Tevo Tarantula. Its very strong and compact. It can travel the whole x-axis. The nozzles ducts are changeable. They are held by friction. Just snap them on and off.
Just print everything.I recommend PLA, because of the tight fit of 40mm Fan Adapter.
I think it is easy to assemble.
(There is also a fully assembled STL, where you can check the the position of the parts. It
It fits the stock X-axis from the Tevo Tarantula. Its very strong and compact. It can travel the whole x-axis. The nozzles ducts are changeable. They are held by friction. Just snap them on and off.
Just print everything.I recommend PLA, because of the tight fit of 40mm Fan Adapter.
I think it is easy to assemble.
(There is also a fully assembled STL, where you can check the the position of the parts. It
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in