Thingiverse
8mm Rod - Storage End Caps
by Jasoncanning
8
Downloads
6
Likes
0
Makes
This is a cap which holds 2 x 8mm rods together to help store them more easily.
If printed correctly you should not be able to slide the rods into the cap very easily, you need to push the rods in from the side until they click into place. To remove them just push the centre nobble downwards to release, then keep pushing the cap around further until the rods are at 90 degrees from the cap, they will then come out easily.
Filament used in the pictures is Fillamentum Vertigo Galaxy PLA.
If printed correctly you should not be able to slide the rods into the cap very easily, you need to push the rods in from the side until they click into place. To remove them just push the centre nobble downwards to release, then keep pushing the cap around further until the rods are at 90 degrees from the cap, they will then come out easily.
Filament used in the pictures is Fillamentum Vertigo Galaxy PLA.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in