Thingiverse
Raspberry PI V2 Camera Holder for Zebra Case
by bigleha1
3
Downloads
2
Likes
0
Makes
This is a Raspberry Pi Camera V2 holder, which attaches to a Zebra case. The model contains a set screw to stabilize a user defined downward camera angle.
Heat set screw inserts (McMaster-Carr 93365A110) were melted in using a soldering iron for 2/56" screws at least 3/8"long to hold the camera and 1/2" long for the angle adjustment.
A 4/40" screw at least 2 1/4" long with nut is used to assemble the three parts.
Tape is used on the case front to ensure the Raspberry Pi3 LED's do not
Heat set screw inserts (McMaster-Carr 93365A110) were melted in using a soldering iron for 2/56" screws at least 3/8"long to hold the camera and 1/2" long for the angle adjustment.
A 4/40" screw at least 2 1/4" long with nut is used to assemble the three parts.
Tape is used on the case front to ensure the Raspberry Pi3 LED's do not
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in