Thingiverse
Tronxy Radial Fan Mount for stock shroud
by WttTmr
2
Downloads
3
Likes
0
Makes
When I just got my Tronxy X1 a part cooling fan was missing. So the bridging performances were very bad. My extruder had alot of problems so I just needed a temporary fix while I made a mount for a V6.
So you just need two M3 screws to put on the side of the shroud and a screw and nut for the Radial Fan. I highly suggest adding a little deflector so your block doesnt cool off too much.
It's a simple solution and I have a friend that uses it for his permanent set up.
NO NEED TO REPOSIT
So you just need two M3 screws to put on the side of the shroud and a screw and nut for the Radial Fan. I highly suggest adding a little deflector so your block doesnt cool off too much.
It's a simple solution and I have a friend that uses it for his permanent set up.
NO NEED TO REPOSIT
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in