Thingiverse
Rectilinear flowerpot 14x14x12 cm
by Movil
11
Downloads
6
Likes
1
Makes
## Sponsored by http://CALE.es the esp32 screen manager
I started this flowerpot as very easy Blender lesson. Initially I wanted to make a mold for concrete. So I left the bottom opened. Cura took great care in closing it for me, I liked the result and at the end never tried to put beton inside :)
Printed it with my Delta at 0.25 layer height and 120 Flow (Otherwise it's too low in my case with a 0.4 Noozle)
I dunno this are the best settings for everyone. But I wanted to print it fast. I
I started this flowerpot as very easy Blender lesson. Initially I wanted to make a mold for concrete. So I left the bottom opened. Cura took great care in closing it for me, I liked the result and at the end never tried to put beton inside :)
Printed it with my Delta at 0.25 layer height and 120 Flow (Otherwise it's too low in my case with a 0.4 Noozle)
I dunno this are the best settings for everyone. But I wanted to print it fast. I
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in