Thingiverse
Filament holder
by Jpeg13
6
Downloads
8
Likes
0
Makes
Hi,
I use this filament holder with my XYZ MiniMaker.
Works fine with 600g and 1KG spools.
The "600g" version will work with almost all spools,if not, try the "1KG" version.
Depending on your filament material, you might need a "not so tight" fit between the long and short axle holders, so i increased the short piece inner radius
from 16,1mm to 16,3 mm.
Let me know if this works for you.
You will need 6 screws M4x20mm with matching nuts,
and a 4mm drill bit to slightly widen the h
I use this filament holder with my XYZ MiniMaker.
Works fine with 600g and 1KG spools.
The "600g" version will work with almost all spools,if not, try the "1KG" version.
Depending on your filament material, you might need a "not so tight" fit between the long and short axle holders, so i increased the short piece inner radius
from 16,1mm to 16,3 mm.
Let me know if this works for you.
You will need 6 screws M4x20mm with matching nuts,
and a 4mm drill bit to slightly widen the h
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in