Thingiverse
Drill starter cup for gas / nitro RC planes
by tfrancis
19
Downloads
12
Likes
0
Makes
Starter cup for use with Hanger 9 starter cones
This uses a 1/4 inch bolt 1 & 1/2 inches long, washer and nut
Print with 4 perimeter, top and bottom layers and 100% infill. Insert the bolt through the cup, tighten insert the cone & it's ready to use
I have included the original 123d design file and *.step file if modifications are needed
This uses a 1/4 inch bolt 1 & 1/2 inches long, washer and nut
Print with 4 perimeter, top and bottom layers and 100% infill. Insert the bolt through the cup, tighten insert the cone & it's ready to use
I have included the original 123d design file and *.step file if modifications are needed
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in