Thingiverse
Anycubic i3 mega part cooling - VERTICAL FAN REMAKE
by BETLOG
188
Downloads
130
Likes
2
Makes
- A fairly extensive hack-job.
This kind of fan does not blow evenly, rather they tend to blow in the direction of blade rotation, so mounting this fan horizontally not only makes it likely something will fall into the inlet, but it also means one side of the cowling will be getting almost all of the air. Mounting them vertically negates both of these completely.
- Does not require supports in this supplied orientation.
- NOTE:
My hotend uses a non-standard heatbreak tube length, and i-
This kind of fan does not blow evenly, rather they tend to blow in the direction of blade rotation, so mounting this fan horizontally not only makes it likely something will fall into the inlet, but it also means one side of the cowling will be getting almost all of the air. Mounting them vertically negates both of these completely.
- Does not require supports in this supplied orientation.
- NOTE:
My hotend uses a non-standard heatbreak tube length, and i-
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in