Thingiverse
Standoff - Filament
by frontrow
1
Downloads
2
Likes
0
Makes
Little standoffs used to run the filament on the side of my DaVinci 1.0 AiO. My spool is mounted with this support https://www.thingiverse.com/thing:700478 in the side opening.
The models are in inches.
Standoff_500 = 1/2 inch from base to center of hole.
Standoff_625 = 5/8 inch from base to center of hole.
The base is 5/8 inch in diameter.
Use whichever you think fits best.
The models are in inches.
Standoff_500 = 1/2 inch from base to center of hole.
Standoff_625 = 5/8 inch from base to center of hole.
The base is 5/8 inch in diameter.
Use whichever you think fits best.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in