Thingiverse
Myford Super 7 - 30 teeth tumbler gear
21
Downloads
6
Likes
0
Makes
I encountered a problem when not paying too much attention when I was threading internal threads on my Myford Super 7 lathe.
It coused the threading bar to run into the inside of the part at hand, and so stall the lathe gearbox and pulling 4 teeth off one of the Tufnol gears.
I thank Myford for designing this safety item, but sadly I didn't have another gear at hand.
Luckily the gear dimensions were not hard to find out. I designed a new spur gear in Solidworks and printed it.
It is runn
It coused the threading bar to run into the inside of the part at hand, and so stall the lathe gearbox and pulling 4 teeth off one of the Tufnol gears.
I thank Myford for designing this safety item, but sadly I didn't have another gear at hand.
Luckily the gear dimensions were not hard to find out. I designed a new spur gear in Solidworks and printed it.
It is runn
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in