Thingiverse
Hypercube Evolution - Chimera Aqua Mount
by VirDim
41
Downloads
22
Likes
0
Makes
This Mount is for an E3D Chimera Aqua and a BL-Touch smart.
!!Keep in mind if the watercooler is not running, it will melt down the mount.!!
For everyone who is looking for the right tubing:
4 mm outer diameter!
Silicone tube works, but is a little bit limp.
I use PTFE tubing same as for the filament, works really fine.
As adpater i use a combination of:
- https://www.conrad.de/de/gerade-verbinder-norgren-aussengewinde-14-rohr-o-4-mm-582994.html
and
- https://www.conrad.de/de/tuelle
!!Keep in mind if the watercooler is not running, it will melt down the mount.!!
For everyone who is looking for the right tubing:
4 mm outer diameter!
Silicone tube works, but is a little bit limp.
I use PTFE tubing same as for the filament, works really fine.
As adpater i use a combination of:
- https://www.conrad.de/de/gerade-verbinder-norgren-aussengewinde-14-rohr-o-4-mm-582994.html
and
- https://www.conrad.de/de/tuelle
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in