Thingiverse
Floo3dPrint rc aircraft/airplane for the hall. Extremely light
by JeWa
108
Downloads
94
Likes
1
Makes
Floo3dPrint
Slow RC aircraft for the hall or at low wind speeds. The flights are printed at 80% and the hull at 90% size. Printed with carbon fiber reinforced PLA. Printer K8200 expanded to 20cm x 40cm.
Wing halves are glued with epoxy resin and then covered with ironing foil.
Tail and elevator 3mm Depron / Epp. Hull bar 4mm carbon fiber rod. Suspension 2mm carbon fiber and 1mm steel rod.
Motor 5gr to 10gr Brushless Ausenläufer. Battery for the hall 250mh 2s. For outdoors 500mh 2s.
Center
Slow RC aircraft for the hall or at low wind speeds. The flights are printed at 80% and the hull at 90% size. Printed with carbon fiber reinforced PLA. Printer K8200 expanded to 20cm x 40cm.
Wing halves are glued with epoxy resin and then covered with ironing foil.
Tail and elevator 3mm Depron / Epp. Hull bar 4mm carbon fiber rod. Suspension 2mm carbon fiber and 1mm steel rod.
Motor 5gr to 10gr Brushless Ausenläufer. Battery for the hall 250mh 2s. For outdoors 500mh 2s.
Center
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in