Thingiverse
Filament Sample Spool
by dukk
30
Downloads
11
Likes
0
Makes
Just a basic filament spool intended to hold samples from my [Maker Box subscription](https://makerbox.cratejoy.com/refer/Justi-EDAAIIFX). This prints in two halves that screw together.
This isn't a remix but it is inspired by https://www.thingiverse.com/thing:2829636. This is a little bigger, uses threads so there is no glue involved, and has a small hole on the inner ring to hold the filament in to help you get started spooling it. It probably would have been a remix if I was any good at e
This isn't a remix but it is inspired by https://www.thingiverse.com/thing:2829636. This is a little bigger, uses threads so there is no glue involved, and has a small hole on the inner ring to hold the filament in to help you get started spooling it. It probably would have been a remix if I was any good at e
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in