Anycubic Kossel Plus - Bed support + insulation + glass with clamp

Starting from the base Yakandu I have added some small clamps to be able to hold the whole assembly without moving. Eliminating the use of big clips on the glass that give problems when leveling or printing parts.

This support is designed to be mounted on an Anycubic Kossel Plus (240mm), where you are using:
-Line cork as insulation
-Original hot bed
-Crystal of 4mm

The total height of the set is 10mm.

For assembly it is necessary:
-2 original M4 screws
-1 nut screw set M3

Here