Big Pushbutton Base / Enclosure

This is a base for Sparkfun's line of Big Dome Pushbuttons (https://www.sparkfun.com/products/9181).

I printed this with ABS and the pushbutton snaps right into the top of the ring.

There are a couple different configurations you can print. Either a basic base for the pushbutton. Or, there's a ring with two built-in brackets for basic 8 ohm speakers and a base with a hole for a slide switch.

The bottom is attached to the ring by 2 M3 screws: https://www.mcmaster.com/#catalog/124/3077/=1