Thingiverse
Coffee Knock Bucket
by Pneuma
8
Downloads
10
Likes
0
Makes
Just a simple coffee knock bucket for your grinds ☕
Designed this with Fusion 360 and seems to be working fine so far. The fit for the pin was a bit tight but have made it smaller now by 0.2mm so should be alright. (It's supposed to be a little bit tight so it doesn't come off)
The body was printed with 20% infill but I think you could go a bit lower probably. I think the cap was 30% and for the pin I would suggest over 80%.
- Use brim/raft for the pin
- Support enabled for the cap
Designed this with Fusion 360 and seems to be working fine so far. The fit for the pin was a bit tight but have made it smaller now by 0.2mm so should be alright. (It's supposed to be a little bit tight so it doesn't come off)
The body was printed with 20% infill but I think you could go a bit lower probably. I think the cap was 30% and for the pin I would suggest over 80%.
- Use brim/raft for the pin
- Support enabled for the cap
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in