Thingiverse
Filament Runout Sensor - for Makerbot/RepRap/Geetech mechanical endstop
by BETLOG
33
Downloads
18
Likes
0
Makes
A filament runout sensor case.
For mechanical endstops.
- Needs:
2 - M3x12 screwed directly into the plastic
- Works for me:
PLA, 0.2mm layers, 0.4mm nozzle, 0.8mm perimeter, 10% infill, no support
- Notes:
- Works better if your filament path is a straight line, the usual curve can cause a little friction. My copy works none-the less, but there's a noticeable difference between testing with a relatively straight section of filament, and actually using it with a spool located in
For mechanical endstops.
- Needs:
2 - M3x12 screwed directly into the plastic
- Works for me:
PLA, 0.2mm layers, 0.4mm nozzle, 0.8mm perimeter, 10% infill, no support
- Notes:
- Works better if your filament path is a straight line, the usual curve can cause a little friction. My copy works none-the less, but there's a noticeable difference between testing with a relatively straight section of filament, and actually using it with a spool located in
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in